Hello,
In such a case, I proceed as follows:
Set up a new "test" model memory.
a) System Setup - Model Select - Add New Model - Create
b) System Setup - Model Type - Multicopter
c) System Setup - Model Name - here: Test
d) System Setup - F Mode Type - Switch1: Switch B
If you now use the Switch B switches, then 3 flight modes are switched, namely from -100/0/+100.
e) Function List - Monitor
Channel 5 (Ger) switches with switch B from 100/0/-100
If you only need 2 switch positions for your FC , then you have to program switch A, for example.
In such a case, I proceed as follows:
Set up a new "test" model memory.
a) System Setup - Model Select - Add New Model - Create
b) System Setup - Model Type - Multicopter
c) System Setup - Model Name - here: Test
d) System Setup - F Mode Type - Switch1: Switch B
If you now use the Switch B switches, then 3 flight modes are switched, namely from -100/0/+100.
e) Function List - Monitor
Channel 5 (Ger) switches with switch B from 100/0/-100
If you only need 2 switch positions for your FC , then you have to program switch A, for example.
